Mobile welding & fabrication in Milton

Aluminum and stainless, yes — TIG, and we prep and clean properly, which is most of the job on aluminum. Cast iron is case by case: some castings can be repaired with nickel rod and controlled preheat and cooling, others will simply crack again beside the weld. We will tell you honestly whether a repair is worth attempting before charging you for it.

If it carries a load — a beam replacing a wall, a balcony, a mezzanine, anything a permit covers — yes, and the fabricator needs the matching certification. We work from your engineer's drawings or can point you to one. For non-structural work like a railing or a gate, no drawings are needed, just measurements.

Typically one to three weeks from final measurement: a day or two to fabricate, time for finishing, then install. Measurement has to happen after the stairs and landings are final, since we build to the actual opening rather than the plan. Rush work is possible and we will tell you the cost rather than quietly missing the date.

Yes. Mild steel outdoors needs protection or it will bleed rust stains down whatever it is bolted to — we prime and paint, or send pieces for powder coating or hot-dip galvanizing depending on the exposure. Galvanizing costs more up front and is the right call for anything exposed to road salt.

With proper precautions, yes, and we take them: combustibles cleared or blanketed, a fire extinguisher at the work, sparks contained, and a fire watch kept for a period after we stop. Most fires from hot work start after the welder leaves, which is exactly why the fire watch is not optional for us.